Controller Settings needed for Plettenberg Xtra30-10 and Hacker-Master 90-O-Acro
10-04-2005 | 05:08 AM
#1
Thread Starter
Senior Member
Joined: Nov 2002
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
From: Haarlem, AK, NETHERLANDS
Controller Settings needed for Plettenberg Xtra30-10 and Hacker-Master 90-O-Acro
I recently bought a hacker-master 90-O-Acro to control a Plettenberg 30-10
Can somebody who is flying the same setup share his controller settings?
I'm mostly interrested in the timing and the frequency settings.
Thanks
Winfried
Can somebody who is flying the same setup share his controller settings?
I'm mostly interrested in the timing and the frequency settings.
Thanks
Winfried
10-04-2005 | 02:15 PM
#2
Senior Member
Joined: Apr 2003
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
From: Saskatoon,
SK, CANADA
RE: Controller Settings needed for Plettenberg Xtra30-10 and Hacker-Master 90-O-Acro
Winfried, Dez Vaghy should be flying that combo. Try emailing him: [email protected]
10-05-2005 | 02:22 PM
#3
Senior Member
Joined: Apr 2003
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
From: Saskatoon,
SK, CANADA
RE: Controller Settings needed for Plettenberg Xtra30-10 and Hacker-Master 90-O-Acro
Whoops, should be [email protected] .
10-10-2005 | 07:18 AM
#4
Thread Starter
Senior Member
Joined: Nov 2002
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
From: Haarlem, AK, NETHERLANDS
RE: Controller Settings needed for Plettenberg Xtra30-10 and Hacker-Master 90-O-Acro
For now I'm flying with these settings:
- No Brake
- 30 degrees timing
- 8 Khz freq
- 3.0 volt per cell switch off
using 21x13, 10S6000 TP
- No Brake
- 30 degrees timing
- 8 Khz freq
- 3.0 volt per cell switch off
using 21x13, 10S6000 TP
