paynezoo

Hey guys, i recently had a thread about a fairly cheap 250 setup, but now im seriously looking into a 600 size. Just because there super stable, good for 3d and arnt so god damn jumpy. So i was wondering what the cheapest set-up would be. I have a rx & tx. I know i need about a 100A esc, i got the general idea, i just dont know the exact servos, motor, ect... Any help would be great
Thanks
-Paynezoo

augerin2

Go with a 550e FBL better power to weight ratio other then that I say the HK 600

paynezoo

How much bigger is the 600 than the 550? i want something big and stable.

paynezoo

anyone else?

AKPhill

600 is about 25% bigger than the 550
But if your looking at the hk600 clonE they have a list of parts needed below there add and there stuff would be the cheapest to get
Now if you ask me what to get I will tell you the best you can afford not the cheapest
Check out the thread on runryder about what just happened last week when a guy got hit with a high quality heli just think a what a low dollar heli can do same thing only faster
Sorry just 2 cents

paynezoo

i dont think safety will be an issue here, i just would like to the know the best, on the cheaper side electronics.

AKPhill

servos   http://www.hobbyking.com/hobbyking/s...g%5F12sec.html

esc   http://www.hobbyking.com/hobbyking/s...F5A%5FBEC.html

motor   http://www.hobbyking.com/hobbyking/s...5FHeli%5F.html

gyro  http://www.hobbyking.com/hobbyking/s...ram%5FBox.html

Battery   http://www.hobbyking.com/hobbyking/s...po%5FPack.html

And your favorite radio gear

paynezoo

ahh thank you

1bbcd5

Great thread! Also my favorite view.

TJ Victor

The plastic one shall be more cheaper than other types,like CF or metal one