LOGO-10 servos
09-11-2003, 04:50 PM
#1
Member
Thread Starter
Join Date: Jul 2003
Location: Southern US
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
LOGO-10 servos
My LOGO-10 came with hitec HS-81 servos - The LOGO calls for 20mm servo horn arms and no one seems to make them that big for the smaller servos so what are LOGO builders doing - using shorter arms, larger servos or grafting onto the small arms?
09-11-2003, 11:34 PM
#2
Member
My Feedback: (1)
Join Date: May 2003
Location: richmond,
KY
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
RE: LOGO-10 servos
I have HS 85 servos and these are what I use on mine in my Logo 10.
[link]http://www.servocity.com/ServoCity/Products/Servo_Horns_Arms/Hitec_Aluminum_Arms/hitec_aluminum_arms.html[/link]
The HS 81's are a little weak for the cyclic though. The 85's are about as low as is recommended.
See ya,
[link]http://www.servocity.com/ServoCity/Products/Servo_Horns_Arms/Hitec_Aluminum_Arms/hitec_aluminum_arms.html[/link]
The HS 81's are a little weak for the cyclic though. The 85's are about as low as is recommended.
See ya,
