Piccolo Pro V2 HELP!
06-20-2003 | 10:18 PM
#1
Thread Starter
Junior Member
Joined: Apr 2003
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: NYC, NY
Piccolo Pro V2 HELP!
i just done assembly of a PiccoloPro
throttle and pitch share a single channel,
problem, when i connect batteries (after recommended
proper start-up programming) , at low stick and zero trim,
the Main Motor just wont stop and i cannot kill motor except
by disconnecting baterries!
PiccoBoard Problem? Or TX programming i overlooked?
(by d way, servo reversing is correct on all channels.)
throttle and pitch share a single channel,
problem, when i connect batteries (after recommended
proper start-up programming) , at low stick and zero trim,
the Main Motor just wont stop and i cannot kill motor except
by disconnecting baterries!
PiccoBoard Problem? Or TX programming i overlooked?
(by d way, servo reversing is correct on all channels.)
