Hi everyone.
im new to edf old time nitro df builder can anyone tell me were i can find a diagram on how to wire 6 channel edf 90 cant find anything that shows step by step
would be every grateful if anyone can help

thanks tom

Completely new to e-flight Tom?

Flight battery capacity, voltage, C-rating?
What controller make/type? High voltage type? Optocoupled? Internal BEC?
Motor type, max. curent, Kv?
Dedicated receiver battery? External BEC?

Multiple choice wiring diagrams, not specific for e-flight
home.kpn.nl/ronvans/scriptasylum→ electrical → system wiring

Keep the battery wires short, or else install extra capacitors. All caps on/near ESC.
Keep controller(s) close to battery if possible, and extend motor wires. No need for extra caps, extra points of failure.
Too long battery wires can kill ESC: precautions, solutions & workarounds - RCG
Contents

• Example Four costly controllers consecutively cremated
• Solutions I & II, rules of thumb
• Problem
• Rubbish! I have no problems.
• Capacitor type & polarity (orientation!)
• How & where (not) to add extra capacitors
• DIY capacitor pack pictures
• Capacitor & pack suppliers
• Expert/manufacturer opinions, they all say the same ... & their rules of thumb
• Explanation, water hammer/knock analogy, theory, references, measurements

Prettig weekend Ron
• Without a watt-meter you are in the dark ... until something starts to glow •
• e-flight calculators • watt-meters • diy motor tips&tricks • Cumulus MFC •

Great move! The days of old noisy vibrators ICDF are well over! What 90mm model are you building? Are you after power set up wiring or all the primary controls? Why don't you visit your local club, the specialists in the field will give you all the help

One of mine last ICDFs, those were the days.
. E-power is taking over of all the flying fields I visit.