OK,
I have finished drawing up my plans for the boat that I'll be building, and it will require a velocity stack to go through one of the supports.

Is there an easy way to make one from around the house kinds of things? I don't have access to a lathe or that kind of stuff. I'll also be rather broke for the next few months, and this would be a good way to spend my broke nites

Is there anything special that I really need to make sure to do/do not do?

Thanks

I saw one made from the neck of a 2 liter Coke bottle and a round piece of plywood. seemed to work fine.

Enjoy,

Jim

Most anything will work.
Your simply trying to capture the spray that comes out of the mouth of the carb.

There is a picture of a velocity stack I made from a plastic bottle ten years ago at:
http://www.rcuniverse.com/forum/m_33.../anchor/tm.htm

Bill