homelite 33 question?
#1
Member
Thread Starter
Join Date: Sep 2006
Location: pilot mountain,
NC
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
homelite 33 question?
Just got my homelite 33 running on the bench. New engine, stock muffler and ignition. Sounds great, getting about 7800 rpm with a MA 18/6. (brought it back down to about 74-7500 for break in). I've run about a tank of fuel through it. I can hear a minute amount of slop in the rod bearings when I jiggle the prop by hand. Doesn't matter if the engine's hot or cold. I don't hear any rattling when the engine is running, but this slop wasn't there before I ran it. Is this normal for these engines?