Lookin for a small (20-30) cc engine to do a conversion from, any suggestions on what to look for? have a 1/5 scale pica t-28 and would rather not spend the money on a G26 for it. any thoughts/suggestions welcome. did come across a few conversions but they weigh in around 4lbs probably way too heavy

This post might be better served if you raise it in the Engine Conversions section of this forum.

Karol

Hi,

Read the Homelite 33 conversion On this forum about half way down this page.

I did a Ryobi 31cc, it worked out well.