RCU Forums - MAC 610 Chainsaw conversion 60cc

RCU Forums (https://www.rcuniverse.com/forum/)

- Engine Conversions (https://www.rcuniverse.com/forum/engine-conversions-92/)

- - MAC 610 Chainsaw conversion 60cc (https://www.rcuniverse.com/forum/engine-conversions-92/10565202-mac-610-chainsaw-conversion-60cc.html)

appy2day

06-09-2011 10:53 AM

MAC 610 Chainsaw conversion 60cc

Are there any of theses conversions still flying? I just got an engine with great compression and will start conversion this weekend. Any extra conversion parts available like sensor brachet or hub with magnet? Thought I would ask before I have to turn one on the lathe. I will have to by a muffler from www.lambertsrc.com, just checked out his webpage.
Happy flying,

appy

appy2day

06-13-2011 07:01 PM

RE: MAC 610 Chainsaw conversion 60cc

1 Attachment(s)

Engine almost free from housing. Need to pull the clutch off. Now which toolbox is that in? Then a good cleaning. Piston and plug look super good.

w8ye	06-13-2011 07:23 PM

RE: MAC 610 Chainsaw conversion 60cc

You are going to need a 22 X 10 prop for it as it is 60cc

captinjohn

06-13-2011 07:26 PM

RE: MAC 610 Chainsaw conversion 60cc

Quote:

ORIGINAL: appy2day

Engine almost free from housing. Need to pull the clutch off. Now which toolbox is that in? Then a good cleaning. Piston and plug look super good.

I hope you dust it off a little!

appy2day

06-14-2011 04:38 PM

RE: MAC 610 Chainsaw conversion 60cc

I have an 85" wingspan "Sweet N Low Stik" that may work as a test bed for the engine. I was going to power it with a 40cc or 50cc anyway. Should be ok. It's a big sucker.
Will order a 22 x 10 prop. this week.
I will get back at it this weekend.

Thanks for the comments.

Happy Flying,
appy

All times are GMT -8. The time now is 02:19 AM.