MAC 610 Chainsaw conversion 60cc
06-09-2011 | 10:53 AM
#1
Thread Starter
Junior Member
Joined: Jun 2005
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
From: Sanbornville,
NH
MAC 610 Chainsaw conversion 60cc
Are there any of theses conversions still flying? I just got an engine with great compression and will start conversion this weekend. Any extra conversion parts available like sensor brachet or hub with magnet? Thought I would ask before I have to turn one on the lathe. I will have to by a muffler from www.lambertsrc.com, just checked out his webpage.
Happy flying,
appy
Happy flying,
appy
06-13-2011 | 07:01 PM
#2
Thread Starter
Junior Member
Joined: Jun 2005
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
From: Sanbornville,
NH
RE: MAC 610 Chainsaw conversion 60cc
Engine almost free from housing. Need to pull the clutch off. Now which toolbox is that in? Then a good cleaning. Piston and plug look super good.
06-13-2011 | 07:26 PM
#4
RE: MAC 610 Chainsaw conversion 60cc
ORIGINAL: appy2day
Engine almost free from housing. Need to pull the clutch off. Now which toolbox is that in? Then a good cleaning. Piston and plug look super good.
Engine almost free from housing. Need to pull the clutch off. Now which toolbox is that in? Then a good cleaning. Piston and plug look super good.
06-14-2011 | 04:38 PM
#5
Thread Starter
Junior Member
Joined: Jun 2005
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
From: Sanbornville,
NH
RE: MAC 610 Chainsaw conversion 60cc
I have an 85" wingspan "Sweet N Low Stik" that may work as a test bed for the engine. I was going to power it with a 40cc or 50cc anyway. Should be ok. It's a big sucker.
Will order a 22 x 10 prop. this week.
I will get back at it this weekend.
Thanks for the comments.
Happy Flying,
appy
Will order a 22 x 10 prop. this week.
I will get back at it this weekend.
Thanks for the comments.
Happy Flying,
appy
