Engine mount for the Poulan 46
 

I have not had luck finding the Hangar 9 mount at the LHS. Does anyone have the part number or a link to it on the internet. I was able to fine a GP adjustable mount for up to a 1.8. Has anyone tried it? I am not sure about it since it is nylon/glass. Are there any other mounts out there that work on the Poulan 46?

Why is an extension piece of aluminum used instead of just bolting directly to the mount?

RE: Engine mount for the Poulan 46
 

Hello.
The GP 1.8 mounts are fine. I couldn't find the H9 mounts either. I have one pair of old ones, but they are to short if used with a Bisson pitts muffler. Wackerengines has the whole setup available including the adapter plates to ease beam mounting. The plates make a more stable mount. Some folks have even made mounts from maple and plywood. Her is a picture by Scott E. of his engine.

Dave

RE: Engine mount for the Poulan 46
 

Is this the Hangar nine mount everyone is using? It has slots in the rails for adjustment.
http://www.horizonhobby.com/Shop/ByC...ProdID=HAN2033

RE: Engine mount for the Poulan 46
 

Ok they are good. You will need either longer mounts or standoffs if you want to use a pitts wrap around muffler.

Dave

RE: Engine mount for the Poulan 46
 

I am not going to try the GP nylon mount. I want to use the aluminum mount that is shown in the picture above. Is that the mount that I linked to above?

RE: Engine mount for the Poulan 46
 

Yes.