help please! honey bee tail rotor bouncing
07-10-2010 | 07:24 PM
#1
Thread Starter
Member
Joined: Dec 2003
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
From: summerville,
SC
help please! honey bee tail rotor bouncing
I just got my new esky honey bee belt drive tail rotor with collective pitch and it flies great but I get a bad bouncing motion from the tail rotor, its like a wobble but instead of wobbling side to side, the tail seems to be bouncing up and down. It settels down after a bit but starts right back up again. Has anyone else had this problem or knows how to stop it? Thanks
07-10-2010 | 11:43 PM
#2
Senior Member
Joined: Mar 2008
Posts: 3,863
Likes: 0
Received 0 Likes
on
0 Posts
From: HornsbyNEW SOUTH WALES, AUSTRALIA
RE: help please! honey bee tail rotor bouncing
ORIGINAL: hornet46
I just got my new esky honey bee belt drive tail rotor with collective pitch and it flies great but I get a bad bouncing motion from the tail rotor, its like a wobble but instead of wobbling side to side, the tail seems to be bouncing up and down. It settels down after a bit but starts right back up again. Has anyone else had this problem or knows how to stop it? Thanks
I just got my new esky honey bee belt drive tail rotor with collective pitch and it flies great but I get a bad bouncing motion from the tail rotor, its like a wobble but instead of wobbling side to side, the tail seems to be bouncing up and down. It settels down after a bit but starts right back up again. Has anyone else had this problem or knows how to stop it? Thanks
In the coaxials that I fly - if the gyro "gain" pot on the side of the 4in1 is too tight it causes the tail to bob up & down. Just a thought[sm=72_72.gif]
Peter[sm=shades_smile.gif]
P.S. I'm going to butt out now mate
07-12-2010 | 12:16 PM
#3
Member
Joined: Jun 2010
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
From: Crestview, FL
RE: help please! honey bee tail rotor bouncing
I also had the same problem with my Co-Comanche. It would fly fine but when I would give it any cyclic input the tail would begin to bounce up and down. As stated above, I also had to adjust my 4 in 1 to resolve the issue.
07-16-2010 | 07:43 PM
#5
Senior Member
Joined: Mar 2008
Posts: 3,863
Likes: 0
Received 0 Likes
on
0 Posts
From: HornsbyNEW SOUTH WALES, AUSTRALIA
RE: help please! honey bee tail rotor bouncing
Hey again Hornet,
From your lack of response - I assume you actually got it to behave!
Great mate![sm=thumbs_up.gif]
Peter[sm=shades_smile.gif]
From your lack of response - I assume you actually got it to behave!
Great mate![sm=thumbs_up.gif]Peter[sm=shades_smile.gif]
