carb pinch bolt
#1
Junior Member
Thread Starter
Join Date: May 2011
Location: Mankato, MN
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
carb pinch bolt
I have a madbash with the go b21 engine and I lost the entire pinch bolt that holds the carb to the engine.
I found one that listed its dimensions at .250 x .750 or 1/4in. x 3/4 inch so i measured the hole on my engine and it matched so i ordered it.
Also I ordered one made by losi and it comes with o-rings.
Patiently awaiting delivery.
I found one that listed its dimensions at .250 x .750 or 1/4in. x 3/4 inch so i measured the hole on my engine and it matched so i ordered it.
Also I ordered one made by losi and it comes with o-rings.
Patiently awaiting delivery.