Removing mounting lugs from engine...?
#1
Thread Starter
Join Date: Dec 2002
Location: Kortessem, BELGIUM
Posts: 3,607
Likes: 0
Received 13 Likes
on
11 Posts
Removing mounting lugs from engine...?
Anybody ever tried this?
I just received my 1/2A Shrike (finally!!...2.5 months...) and I will have a hard time fitting anything bigger than a 0.061 engine...
If I can remove the mounting lugs it will be easy, but I think those mounting lugs contribute a lot to the crankcase integrity...
How much can I shave off without the engine coming apart when it's running...?
I just received my 1/2A Shrike (finally!!...2.5 months...) and I will have a hard time fitting anything bigger than a 0.061 engine...
If I can remove the mounting lugs it will be easy, but I think those mounting lugs contribute a lot to the crankcase integrity...
How much can I shave off without the engine coming apart when it's running...?
#2
Senior Member
Join Date: Nov 2002
Location: camborne, UNITED KINGDOM
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
RE: Removing mounting lugs from engine...?
i dont think i would like to remove more than 2/3 of the width.
try it! i THINK it might void the warranty though!!
try it! i THINK it might void the warranty though!!
#3
Senior Member
My Feedback: (1)
Join Date: Jan 2002
Location: Bridgeton, NJ
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
RE: Removing mounting lugs from engine...?
Rudeboy:
Have cut 75% off the engine mount on Webra 32s with out
problems and had no problems even after a nose down
crash. Did this on several engines...
Syd
Have cut 75% off the engine mount on Webra 32s with out
problems and had no problems even after a nose down
crash. Did this on several engines...
Syd