Anyone Know of a Custom Header Maker?
#1
Senior Member
Thread Starter
My Feedback: (9)
Join Date: Mar 2002
Location: Orange,
CA
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
Anyone Know of a Custom Header Maker?
Well I got the Macs Fuse Top header for my EZ Dago Red the original kit not the new one. I want to run my new YS 61 RL rear exhaust long stroke. Well I got my header today and it will not clear the bottom of the fuselage with the engine inverted in the stock position. So I cannot mount up the pipe because I dont have the clearance from the header and its the biggest rise that Macs makes. Does anyone know of a custom Header pipe maker that can make me a header so I can install my YS 61 RF rear exhaust inverted in the stock position?
Any help is appreciated
Thanks Viper.
Any help is appreciated
Thanks Viper.
#2
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: CamborneCornwall, UNITED KINGDOM
Posts: 6,136
Likes: 0
Received 0 Likes
on
0 Posts
Anyone Know of a Custom Header Maker?
Just Engines over here will make it any shape you want and send it over in a flash
http://www.justengines.unseen.org/
http://www.justengines.unseen.org/
#4
Senior Member
Thread Starter
My Feedback: (9)
Join Date: Mar 2002
Location: Orange,
CA
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
Headers
I have been through the whole deal with Macs before when I needed a special header made and it cost me a fortune and it did not fit well. Ended up with a plane that I could not install my pipe on. If anyone has any suggestions please let me know.
Thanks Viper
Thanks Viper
#5
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: CamborneCornwall, UNITED KINGDOM
Posts: 6,136
Likes: 0
Received 0 Likes
on
0 Posts
Anyone Know of a Custom Header Maker?
looks like my post is only visible to me, so heres what i wrote
www.justengines.unseen.org
Just Engines over here will make it any shape you want and send it over in a flash
#6
Senior Member
Thread Starter
My Feedback: (9)
Join Date: Mar 2002
Location: Orange,
CA
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
Found
Well I finally found someone in this hemisphere that can make me a custom header. He does not like to have his email let out so I can put here but he can make me what I need. So my Dago Red is almost set I just need to take the measurements and draw a sketch of the header and fax it too him. Too cool I knew that there was someone that was closer than the UK and that could do it right away Hopefully I will have my Dago Red flying in a couple of weeks,
Viper
Viper