Question for Bob27s
I am putting together a Cermark Alley Cat. I had a bit of a hard time getting my Jett 90LX to fit. Ive got the engine mounted on their about the best that I can. I had to butcher up the motor mounts a little and shim up the rear of the engine. The muffler still wont quite clear the fuselage. I was wondering if I could make say a 1/4 inch extension plate out of aluminum for the muffler so I can get it to fit on the Plane? Will this affect the engine?
|
RE: Question for Bob27s
Don't they make muffler extensions? Bob will get that sorted out for ya-
A nicer and more knowledgeable guy you will not find. Got any pics though? :D |
RE: Question for Bob27s
1 Attachment(s)
ORIGINAL: Hanger 18 I am putting together a Cermark Alley Cat. I had a bit of a hard time getting my Jett 90LX to fit. Ive got the engine mounted on their about the best that I can. I had to butcher up the motor mounts a little and shim up the rear of the engine. The muffler still wont quite clear the fuselage. I was wondering if I could make say a 1/4 inch extension plate out of aluminum for the muffler so I can get it to fit on the Plane? Will this affect the engine? The plane was designed for "50" size power, or a YS63, so it does indeed take some work to squeeze in the big-block engine. It is most definately not a drop-in fit. Do you have the "Toni" muffler extention kit for the 90LX engine? That is required for the Alleycat installation. Provides extention, plus some additional angle. Bob |
RE: Question for Bob27s
I was looking at the Jett site for a muffler extension I guess I overlooked it. Time to order one and another 90LX for my Cermark F-18.[8D]
|
All times are GMT -8. The time now is 04:20 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.