Mini-iOSD Problems.
01-07-2015 | 11:02 AM
#1
Thread Starter
Junior Member
Joined: Dec 2014
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
From: Victoria, TX
Mini-iOSD Problems.
I've been working on my Mini-iOSD problem for the last 3 days.
I have a P2 Ver. 1.0, Black Pearl monitor, 600mw transmitter. I get a blank screen. No video or OSD info. If I run the camera video direct to the transmitter, I see video. I replaced the video in/out cable to the Mini-iOSD. No dice. I've checked my wiring over and over again. My question is my NAZA. I don't see the V2 printed on the NAZA label. It just says NAZA. Please see attached.
I'm also going to add the BTU and Data ground station later. If my NAZA Version is the problem, I may be in bigger problems.
What do you think?
I have a P2 Ver. 1.0, Black Pearl monitor, 600mw transmitter. I get a blank screen. No video or OSD info. If I run the camera video direct to the transmitter, I see video. I replaced the video in/out cable to the Mini-iOSD. No dice. I've checked my wiring over and over again. My question is my NAZA. I don't see the V2 printed on the NAZA label. It just says NAZA. Please see attached.
I'm also going to add the BTU and Data ground station later. If my NAZA Version is the problem, I may be in bigger problems.
What do you think?
