FUTABA 10CG FLAP PROGRAMMING
12-27-2010 | 04:48 PM
#1
Thread Starter
Senior Member
Joined: May 2003
Posts: 842
Likes: 0
Received 0 Likes
on
0 Posts
From: mississauga,
ON, CANADA
FUTABA 10CG FLAP PROGRAMMING
I'm struggling to programm my flaps on a TF SEA FURY on a FUTABA 10 CG. I followed word by word instructions using channel 6 and 8 (aux) ch. and activating the flaps by switch "D". No luck. Need help, can someone give me some instructions of how to go about it ?
I'm using a 2.4ghz rx (10 ch) Two Hitech servos 5645mg using channel 6 and 8 as aux. When down switch activated one servo is lagging a few seconds behind. Is there a way on this 10c that makes flaps deploy smoother ? Need help. Thanks
Charles.
I'm using a 2.4ghz rx (10 ch) Two Hitech servos 5645mg using channel 6 and 8 as aux. When down switch activated one servo is lagging a few seconds behind. Is there a way on this 10c that makes flaps deploy smoother ? Need help. Thanks
Charles.
12-28-2010 | 09:16 AM
#3
Thread Starter
Senior Member
Joined: May 2003
Posts: 842
Likes: 0
Received 0 Likes
on
0 Posts
From: mississauga,
ON, CANADA
RE: FUTABA 10CG FLAP PROGRAMMING
