Futaba T9CAP programing help
12-28-2010 | 02:55 PM
#1
Thread Starter
Junior Member
Joined: Jan 2005
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: WoodRidge, NJ
Futaba T9CAP programing help
Hi , I am new to Futaba radios (use JR) I just got T9CAP and studied on line manual for hours.
What I like to do is program the radio so with the flip of the switch A or D or any other I could free the throttle stick for pan and tilt, leaving the throttle on sort of cruise position.
So I am flying get the comfortable speed (throttle) , flip the switch and use the stick for pan(left-right) and tilt (up -down), then flip the switch again to get full throttle control again.
Since I am not very familiar with this radio step by step guide would be greatly appreciated.
What I like to do is program the radio so with the flip of the switch A or D or any other I could free the throttle stick for pan and tilt, leaving the throttle on sort of cruise position.
So I am flying get the comfortable speed (throttle) , flip the switch and use the stick for pan(left-right) and tilt (up -down), then flip the switch again to get full throttle control again.
Since I am not very familiar with this radio step by step guide would be greatly appreciated.
12-29-2010 | 01:04 PM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: Futaba T9CAP programing help
Doing this with a "condition" would be simple enough, but the 9C series just doesn't have this capability. You would need to go with at least an old 9Z or a current 12FG, 12Z or 14MZ transmitter.
I am sorry the radio you have is just not capable of this type of mix.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
I am sorry the radio you have is just not capable of this type of mix.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
