I asked this question in another forum & they sugested i ask it here so here go's.i have a futaba 9cap super transmitter and would like to asign flapsandajust them for 18% & 30%flapsto one of the 3 position switchs. without using airbrakes or flaporons.i'm usinga 9 channel receiver.anyone know how to do this? if it can be done.
Thanks for your help
Mike.

To do this, you would need to create Offset Pmixes.

First go into a blank Mix, set the Master as Offset, the slave as Flap, and activate the mix. Set this to any 3 position switch you would like to control this function, set the switch to activate in the Center position, set Link as On, and set the rate to 18%.

Now go into the next free mix, setting the very same configuration, but this time set the rate to 30%.

This sounds like what you may be looking for.


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]