CIU-2 Help
08-29-2011 | 03:02 PM
#1
Thread Starter
Senior Member
My Feedback: (1)
Joined: Jan 2009
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
From: Torrance,
CA
CIU-2 Help
I received my CIU-2 device today and the instructions are non existent. I went to the Futaba site and downloaded the updates for Windows 7 to get the proper drivers. So, how do I make the connections to the gyro??? What gets plugged in and what doesn't??? Is the heli powered up or not??
I am showing a green LED light on the CIU.
When I do make what I think are the right connections, I get an "READ ERROR MESSAGE". [&o]
Mike
I am showing a green LED light on the CIU.
When I do make what I think are the right connections, I get an "READ ERROR MESSAGE". [&o]
Mike
08-30-2011 | 06:30 AM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: CIU-2 Help
You will find instructions and hook up diagrams on our website at:
http://downloads.hobbico.com/softwar...10_ENG_web.pdf
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
http://downloads.hobbico.com/softwar...10_ENG_web.pdf
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
08-31-2011 | 07:27 AM
#3
Thread Starter
Senior Member
My Feedback: (1)
Joined: Jan 2009
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
From: Torrance,
CA
RE: CIU-2 Help
Hi Krysta
This doesn't help at all. I am using the CIU with a GY520 gyro. There is very little information on how to use, make connections, and the different parameters that are adjustable once you get to the programming phase of the gyro itself.
Mike
This doesn't help at all. I am using the CIU with a GY520 gyro. There is very little information on how to use, make connections, and the different parameters that are adjustable once you get to the programming phase of the gyro itself.
Mike
