Help ! 10C - parameter function
07-02-2012 | 01:24 PM
#1
Thread Starter
Senior Member
Joined: Aug 2006
Posts: 283
Likes: 0
Received 0 Likes
on
0 Posts
From: Pontiac, MI
Help ! 10C - parameter function
I am trying to setup an airplane in acro mode. it has 4 wing servos. 1 Lft Ail and 1 Lft Flp + 1 Rt Flp and 1 Rt Ail. I want to be able to setup airbrakes as well as flaps.
WHAT the heck do I set the AILE-2 to ?
I have a 14 channel rx.
WHAT the heck do I set the AILE-2 to ?
I have a 14 channel rx.
07-03-2012 | 09:26 AM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: Help ! 10C - parameter function
This would depend on where you have each of these plugged into your receiver, as you could use either setting.
Please let us know your receiver layout.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
Please let us know your receiver layout.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
