Hello,

Is it possible to run the teacher tx in mode 1 and the student tx in mode 2?

I have a 14MZ, the other transmitter is a 9 super or 7 CAP (all Futaba).

The 14mz manual does not say anything about modes in the trainer section so I assume this is possible.

Any information would be great!

Thank you,

Ralf

A long as the two transmitters have the channels mapped as folows, it will work:

channel 1 = aileron
channel 2 = elevator
channel 3 = throttle
channel 4 = rudder

A "true" mode I transmitter will just have channels 2 and 3 working off different sticks. A proper mode change changes not only the stick springs and ratchets, but the channel mapping, too.

Thank you, will try this weekend and keep you posted,

Rgds,
Ralf