7C programming - VR at 0% when moving Channel 2
#1
Junior Member
Thread Starter
Join Date: Dec 2005
Location: Chicago,
IL
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
7C programming - VR at 0% when moving Channel 2
I am trying to do a mix on my 7CHP.
I have it in ACRO mode, with the gyro's (GY401) sensitivity controlled through the Channel 6 VR knob. I would like to have the sensitivty temporariy switch to 0% when I move the joystick on channel 2.
Once I let go of the joystick, I would like the setting on channel 6 to return to where I had it dialed in.
I was told that this is possible, but I don't know where to start.
Thanks
-Brian
I have it in ACRO mode, with the gyro's (GY401) sensitivity controlled through the Channel 6 VR knob. I would like to have the sensitivty temporariy switch to 0% when I move the joystick on channel 2.
Once I let go of the joystick, I would like the setting on channel 6 to return to where I had it dialed in.
I was told that this is possible, but I don't know where to start.
Thanks
-Brian
#2
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: 7C programming - VR at 0% when moving Channel 2
Hi Brian,
Let me check with one of our heli people and I will try to get back to you this afternoon.
Thanks, Krysta
Let me check with one of our heli people and I will try to get back to you this afternoon.
Thanks, Krysta
ORIGINAL: Justabeginner
I am trying to do a mix on my 7CHP.
I have it in ACRO mode, with the gyro's (GY401) sensitivity controlled through the Channel 6 VR knob. I would like to have the sensitivty temporariy switch to 0% when I move the joystick on channel 2.
Once I let go of the joystick, I would like the setting on channel 6 to return to where I had it dialed in.
I was told that this is possible, but I don't know where to start.
Thanks
-Brian
I am trying to do a mix on my 7CHP.
I have it in ACRO mode, with the gyro's (GY401) sensitivity controlled through the Channel 6 VR knob. I would like to have the sensitivty temporariy switch to 0% when I move the joystick on channel 2.
Once I let go of the joystick, I would like the setting on channel 6 to return to where I had it dialed in.
I was told that this is possible, but I don't know where to start.
Thanks
-Brian
#4
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: 7C programming - VR at 0% when moving Channel 2
Hi Bryan,
We are not sure how someone has set this to the VR knob. We can set it up on a 3 position switch but cannot get this done on the dial.
Sorry we couldn't help you further. Krysta
We are not sure how someone has set this to the VR knob. We can set it up on a 3 position switch but cannot get this done on the dial.
Sorry we couldn't help you further. Krysta
ORIGINAL: Justabeginner
By chance has anyone looked into this further?
Thanks
By chance has anyone looked into this further?
Thanks