10C compatibility with R606FS RX?
#1
Thread Starter
Join Date: May 2007
Location: Arvada, CO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
10C compatibility with R606FS RX?
The compatibility chart on the FASST web site says that the T10C module is compatible with the R606FS in 7ch mode, yet page 8 of the (preliminary) 10C manual seems to indicate that it is not. I am hoping that this is a typo in the manual and not the website as I backordered a 10C months ago on the information posted on the web site that the 10C would be compatible with my five R606FS receivers. If these are _not_ compatible, I need to know ASAP so that I can cancel my order before it gets shipped.
#2
Senior Member
Join Date: Jan 2002
Location: Stansbury Park,
UT
Posts: 937
Likes: 0
Received 0 Likes
on
0 Posts
RE: 10C compatibility with R606FS RX?
I can't find the thread, but it's already been answer that yes, the 606FS receiver is compatible with the 10C FASST system. It wasn't listed in the manual because the manual was written after the 606 receiver was discontinued.
#3
Thread Starter
Join Date: May 2007
Location: Arvada, CO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
RE: 10C compatibility with R606FS RX?
ORIGINAL: garys
I can't find the thread, but it's already been answer that yes, the 606FS receiver is compatible with the 10C FASST system. It wasn't listed in the manual because the manual was written after the 606 receiver was discontinued.
I can't find the thread, but it's already been answer that yes, the 606FS receiver is compatible with the 10C FASST system. It wasn't listed in the manual because the manual was written after the 606 receiver was discontinued.
#4
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: 10C compatibility with R606FS RX?
Yes, these are compatible in 7ch mode with the R606FS receiver.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]