Hi
I am trying to program dual elevators servos on my 14MZ. I have managed to getting them working by having Elevator and Elevator 2 both set to the same stick and trim but when I go to set up dual rates I have to set up a seperate dual rate for Elevator 1 and Elevator 2. Which takes up four of my available dual rates. Is there another way to do it that is less hassle and only takes up only one set of dual rates instead of two?

Mike

Hi
Figured it out for myself. Just set the channel I had the other Elevator servo to Elevator not Elevator 2 and it worked a charm. I am guessing I only need to have it set to Elevator 2 if I need to have some reversing or throw modification independent to the Elevator channel.

Four years I have been living with this beast and I am still learning.

Mike

Normally, you'd set up the airplane with the "Ailevator" tail type. Then, it will automatically have you set up for dual elevators. The dual rates will then work properly.