12fg setup for twin!
#1
Member
Thread Starter
Join Date: Jan 2003
Location: Lower Pottsgrove,
PA
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
12fg setup for twin!
i have a fass 12fg that i would like to program a twin engine set up . I have 6014fs reciever. I would like to have idle down and kill setup. I would also like to have sub trims for each motor. if possible I would like to disable stick from either motor for tuning. Please help me with the best possible setup for twin motors.
I tried to slave channel #7 But idle down and stop would only work channel #3,
I tried to slave channel #7 But idle down and stop would only work channel #3,
#2
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: 12fg setup for twin!
While this FAQ was written for the 14MZ, the scenario will also work for your 12FG. We hope this helps you out:
http://www.14mz.com/faq/faq-14mz-q859.html
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
http://www.14mz.com/faq/faq-14mz-q859.html
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]