7c Conquest
06-23-2010 | 10:40 PM
#1
Thread Starter
Senior Member
Joined: Apr 2010
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
From: Pearland,
TX
7c Conquest
I know there are a lot of forms about trainer cords. I know that I can make my conquest work with my 7c if I send it in to futaba and have something done to it. What I need to know is how do I go about doing this where do I send it. How much dose it cost to have it done and what do they do to it
06-25-2010 | 08:16 AM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: 7c Conquest
The older 4VF Skysport or the 4NBF Conquest transmitters can be sent into the Service Center for a free update that will allow them to work with the 7C via the trainer cord.
Please see our sticky at the top of this page for the address to ship this to.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
Please see our sticky at the top of this page for the address to ship this to.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
