Help with 9C and Ultra Stick programming
 

Hey,

Manual on Ultra Stick said to setup 9C in Glider mode. This takes away the throttle cut and snap roll functions. Can I add snap-roll and Throttle cut to glider? Or can I set up all the glider functions in the aero mode? I have four servos in the wings for seperate flaps and ailerons. I would like them to function properly as Flapperons and Flaps. If this can't be programmed I'd like to at least have flaps with elevator mixing. So far I have not been able to get the Channel 1 and 7 servos to work with Flaps in the Aero mode. Flaps are on channels 5 and 6.

Thanks

Dave

RE: Help with 9C and Ultra Stick programming
 

Hi Dave,

You would want to set this up in Acro mode with the 9C. Also please check our FAQ's they can walk you through this step by step.

http://www.futaba-rc.com/faq/faq-9c-q515.html

I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.

Sincerely,
Krysta
Lead Futaba Customer Service and Progamming Technician

RE: Help with 9C and Ultra Stick programming
 

Thanks Krysta I'll give this a try.

Dave