synthesized transmitter module tool to change channels
 

I just purchased a used 9cap with a synthesized transmitter module. My question is do I need a special screw driver to change the channel? In ppictures I see the plactic one used.
H e l p ......

RE: synthesized transmitter module tool to change channels
 

Hi Richb1942
A small ordinary screwdriver will do the job just as well
Regards
Styk

RE: synthesized transmitter module tool to change channels
 

Hi richb1492,

If you purchased this transmitter new, the plastic screw driver should have been included.

If you would like, we'll be happy to send you one, just contact us at [email protected] and we'll get your address to mail one out to you.


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]