Fail Safe Procedure
 

What is the recommended way to check if failsafe is working correctly?
thanks
gatorb8

RE: Fail Safe Procedure
 

You just turn off your transmitter. Upon signal loss, receivers with failsafe should go into the desired failsafe condition.

RE: Fail Safe Procedure
 

Thanks,
After turning the transmitter off, it goes to failsafe.
If I turn my transmitter back on, it will control the plane again.
If I turn the transmitter off again, should it go to failsafe again?
Gatorb8

RE: Fail Safe Procedure
 

If you wait a moment, after you've turned the transmitter back on, and then turn it off. The receiver should go into failsafe again.

RE: Fail Safe Procedure
 

thanks Bax,
I'm trying to figure out why my transmitters act differently, I'll check some more and try to see if I can repeat it, I'll let ya know.
gatrob8