What is the recommended way to check if failsafe is working correctly?
thanks
gatorb8

You just turn off your transmitter. Upon signal loss, receivers with failsafe should go into the desired failsafe condition.

Thanks,
After turning the transmitter off, it goes to failsafe.
If I turn my transmitter back on, it will control the plane again.
If I turn the transmitter off again, should it go to failsafe again?
Gatorb8

If you wait a moment, after you've turned the transmitter back on, and then turn it off. The receiver should go into failsafe again.

thanks Bax,
I'm trying to figure out why my transmitters act differently, I'll check some more and try to see if I can repeat it, I'll let ya know.
gatrob8