Hi. I acquired a Brison 3.2 with about 20 runs so far. I intend to use it on a Hanger 9 80" Cap. What would be a good brand/size prop for basic 3D and scale like flight?? Thanks in advance

Menz S 22x8 works for me.

Hall

Mejlick 21x10 for lower noise and more scale like stuff...
MSC 22x8 for 3D stuff...Excellent dowline braking too.

Cheers.

Who carrys MSC props? I am not familiar with the brand. Thanks

Hi,
Check out this thread:
http://www.rcuniverse.com/forum/Bris..._461234/tm.htm
Thanks
John

I would try an Airwild 21x8 propeller until it is broken in.

I have a new 3.2 that just went on my Edge. Have'nt flown it yet but when I ordered the engine from Brison I asked what prop they recomend for a light weight 80" plane and they said a MSC 22-10. I have a Zinger pro 22-8 which is what the engine was test run with and the tag said 7530rpm w/Zinger pro 22-8. Get one of each and see which is best for your setup since different planes will favor different props on the same engine.