I guess even some of us old geezers can use some help now and then. I am just getting into Gas engines (been modeling 40+ years). What is the best way to install a kill switch on an engine with electronic ignition? Fuji 50 eis.

Thanks for your time fellas, Harry

Hi Harry,

Most of us use this:

http://www.smart-fly.com/Products/Ignition/ignition.htm

There is a how-to here on RCU for installing it. Total weight is something like one-half ounce and really simple to use and allows you to kill the engine in the air. If all power is lost to the receiver than it kills the ignition.

http://www.rcuniverse.com/magazine/a...article_id=375

Thanks Bill, I just put one on order.

Harry

That thing works great. Just plug it in to an unused channel and assign a switch. Switch off for priming and on when your ready to start.

Todd

There is also this one available.

http://www.electrodynam.com/cgi-loca...517+1146204322