Precision Eagle 4.2 gas--where to get parts
09-28-2007, 07:45 PM
#1
Thread Starter
My Feedback: (67)
Join Date: Jun 2002
Location: Liberty,
SC
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
Precision Eagle 4.2 gas--where to get parts
I have an older Precision Eagle or Eaglet, not sure which, and I need a prop shaft adaptor. The new Precision Eagle engine looks different than mine. Anyone know where I can get the part?
09-28-2007, 07:53 PM
#3
My Feedback: (90)
Join Date: Dec 2001
Location: Elephant Butte, N.M.
Posts: 6,715
Likes: 0
Received 2 Likes
on
2 Posts
RE: Precision Eagle 4.2 gas--where to get parts
Are you looking for the 4-bolt to single shaft similar what is shown here? If so check with C&H Ignition. http://www.ch-ignitions.com/ They make this six bolt version.
09-28-2007, 08:02 PM
#5
Thread Starter
My Feedback: (67)
Join Date: Jun 2002
Location: Liberty,
SC
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
RE: Precision Eagle 4.2 gas--where to get parts
Thanks Guys. The photo of the shaft is exactly what I need.
The engine has been a great performer. Flown it for 7 years. Never failed me till this past June. Had it on a 25 pound Carden extra 300. Doing my usual Lumchavak on takeoff. 3 tumbles going up to about 200 feet. Then silence. No air speed, no power. Not enough altitude to glide out. At least it hit at an angle. I had used the same prop for those 7 years.
The engine has been a great performer. Flown it for 7 years. Never failed me till this past June. Had it on a 25 pound Carden extra 300. Doing my usual Lumchavak on takeoff. 3 tumbles going up to about 200 feet. Then silence. No air speed, no power. Not enough altitude to glide out. At least it hit at an angle. I had used the same prop for those 7 years.
