DA needle settings
02-03-2008 | 06:04 PM
#1
Thread Starter
Senior Member
My Feedback: (3)
Joined: Oct 2003
Posts: 382
Likes: 0
Received 0 Likes
on
0 Posts
From: palmyra,
VA
DA needle settings
I am in Virginia and I run Ammsoil 100:1, can anyone tell me about where both of my needles should be? I have two da 100's and both run well, but the are not set anywhere near one another. I know they should be about 2 turn out for break in, but these are already broken in. One was 1/2 turn out for the idle and the other was 1 1/2. Any help would be appreciated.
02-03-2008 | 08:01 PM
#2
My Feedback: (1)
Joined: May 2003
Posts: 789
Likes: 0
Received 0 Likes
on
0 Posts
From: North Las VegasNV
RE: DA needle settings
The factory as you know gives you initial settings, then you idle them in from there.
I have a DA 50R and my low end needle is about what you said yours is. I don't remember what the high needle setting is but what you said yours is sounds about right.
I was surprised at my settings too.
I have a DA 50R and my low end needle is about what you said yours is. I don't remember what the high needle setting is but what you said yours is sounds about right.
I was surprised at my settings too.
