Led to shown ignition on
08-25-2008 | 10:05 AM
#1
Thread Starter
Led to shown ignition on
Not being very electrical or electronically minded, is there an easy way to tie in a led light to show 'ignition on' in the ignition battery /switch circuit, and if so how?
Karol
Karol
08-25-2008 | 11:15 AM
#2
Member
My Feedback: (2)
Joined: Nov 2007
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
From: Louisville,
KY
RE: Led to shown ignition on
Try this
Use a 100 ohm resistor is series with the LED for 4.8v packs
about 150 ohm resistor for 6 volt.
It's not critical, just to current leimit the LED.
It will draw about 20mA so don't worry about draining your battery
Use a 100 ohm resistor is series with the LED for 4.8v packs
about 150 ohm resistor for 6 volt.
It's not critical, just to current leimit the LED.
It will draw about 20mA so don't worry about draining your battery
