G-62 kill switch help needed!
#1
Member
Thread Starter
My Feedback: (17)
Join Date: Sep 2004
Location: Camden,
SC
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
G-62 kill switch help needed!
Ok, I've been at this for awhile, but I'm finally stumped! I have a never-been-run Zenoah G-62 engine, and trying to install a GP kill switch. The trouble is, there's no black wire and no blade on the mag or the coil! See the attached pic. So, what do I need to do to connect the kill switch???
Thanks for any help.
Ed
Thanks for any help.
Ed
#2
Senior Member
My Feedback: (4)
Join Date: Jul 2002
Location: Somewhere,
DC
Posts: 9,825
Likes: 0
Received 0 Likes
on
0 Posts
RE: G-62 kill switch help needed!
All G62s have a black wire coming out of the source coil...I have thrown a few thousand away in the last 23 years of converting engines...
I kept a few...If you want one send me a few bucks for postage...
If you just gotta buy one they're about $40 bucks from Horizon...
There is no blade on a G62 source coil...
Sent you a PM..
I kept a few...If you want one send me a few bucks for postage...
If you just gotta buy one they're about $40 bucks from Horizon...
There is no blade on a G62 source coil...
Sent you a PM..
#3
Member
Thread Starter
My Feedback: (17)
Join Date: Sep 2004
Location: Camden,
SC
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
RE: G-62 kill switch help needed!
ORIGINAL: Antique
All G62s have a black wire coming out of the source coil...I have thrown a few thousand away in the last 23 years of converting engines...
I kept a few...If you want one send me a few bucks for postage...
If you just gotta buy one they're about $40 bucks from Horizon...
There is no blade on a G62 source coil...
Sent you a PM..
All G62s have a black wire coming out of the source coil...I have thrown a few thousand away in the last 23 years of converting engines...
I kept a few...If you want one send me a few bucks for postage...
If you just gotta buy one they're about $40 bucks from Horizon...
There is no blade on a G62 source coil...
Sent you a PM..
Thanks,
Ed