HELP Please!!!!!
 

Please help guys. I have a 35cc Maccullogh engine converted for RC use. I can't get it to run. It doesn't seem to pump gas. Please look at the pic of the carb and tell me which fitting I need to attach the gas the gas line to. #1 or #2 I am pulling my hair out.

http://farm4.static.flickr.com/3464/...06ed93cc18.jpg
walbro by prebres, on Flickr

RE: HELP Please!!!!!
 

Gas to #1, cap off #2. Not sure but I'm guessing #2 was for a primer. Make sure the diaphram under the cover near #1 is flexible and that the pump flappers are not curled or otherwise distorted. Also, be sure the diaphram under the cover with the 4 retaining screws is also flexible and that the metering needle also moves freely. You might need a rebuild kit if the carb has very much use on it.

RE: HELP Please!!!!!
 

Thank you Truckracer.

RE: HELP Please!!!!!
 

Yours is a Wt Series carb. Here is the maint manual for it. http://wem.walbro.com/distributors/s...s/WTseries.pdf

Don

RE: HELP Please!!!!!
 

Awesome, thanks Campgems.