RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Gas Engines (https://www.rcuniverse.com/forum/gas-engines-142/)
-   -   Quadra Help (https://www.rcuniverse.com/forum/gas-engines-142/11348442-quadra-help.html)

BChris 12-29-2012 10:11 AM

Quadra Help
 
gentlemen,

I recently received a 1/3 scale cub with an unmounted engine that supposedly came out of it. The engine is marked as a Quadra 42 and has a large Quadra fly wheel on it. The casing is a 2 piece casing split front to back with a large cup type motor mount and has a Bennet muffler. There is a large nipple between the casing and the muffler and I have no idea what I am supposed to hook to it. I am guessing that the spade connector on the the magneto would wire to an on off switch and the other side of the switch back to the engine as a ground ??? Is there anything that I need to look for or things to check before I mount this back on the plane. It has a 22 8 prop mounted on it and seems to have really good compression. The muffle has 2 small nipples on it which I am guessing might have went to an old smoke system. Any and all help would be greatly appreciated.

Brad

w8ye 12-29-2012 10:41 AM

RE: Quadra Help
 
The Quadra 42 used a 18 X 10 prop.

The Quadra 50 used a 22 X 8 prop or it could have a 20 X 10.

The Quadra 42 has the cylinder and the top half of the crankcase as one piece. The bottom half of the crankcase is just a cap. The muffler is on the rear.

The quadra 50 has a separate cylinder and a crankcase that is split and there is a front part and a rear part of the crankcase. The muffler is on the side.

[youtube]http://www.youtube.com/watch?v=v6Dp-XiBo1s[/youtube]

Q-50 with the cylider turned around.
http://i45.photobucket.com/albums/f9...uadra501-1.jpg
http://i45.photobucket.com/albums/f9...4/quadra50.jpg

Quadra 42
[youtube]http://www.youtube.com/watch?v=8DYGytiCikA[/youtube]

This one doesn't have a Bennett muffler
http://static.rcgroups.net/forums/at...us41engine.jpg

This 42 has a Bennett muffler but RCEXL ignition
http://images.rcuniverse.com/forum/u...38/ze85123.jpg


Truckracer 12-29-2012 11:10 AM

RE: Quadra Help
 
The large nipple on the crankcase probably connected to a line that went to a Bennett style smoke pump. These were very common a few years back.

I'd think a 1/3 scale CUB would need at least a 50cc engine for acceptable performance.


All times are GMT -8. The time now is 09:46 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.