Valley View Props?
I have a new EME-35 that I am breaking in on a FLY-MODEL Yak-54. I started breaking in the 35 with a Turnigy 19x8 because that is what I had on hand at the time. It seemed to do pretty well and I was getting 7100RPM on the high end with a good 1700RPM at idle. I came across these Vally View props and I thought I would give them a try. I notice an increase in 200rpm with these props. I did the maiden flight with the Valley View 19x8 prop and the Yak had unlimited vertical. I am new to this type on plane and I was wondering what everyone thinks of these Valley View props?:confused:
|
Haven't tried their props but we sure like their engines!
|
The props I have from VVRC work well . They tend to have a little less pull then the same size Zoar but work well.
|
I like them!
|
Originally Posted by jstanton
(Post 12072933)
I have a new EME-35 that I am breaking in on a FLY-MODEL Yak-54. I started breaking in the 35 with a Turnigy 19x8 because that is what I had on hand at the time. It seemed to do pretty well and I was getting 7100RPM on the high end with a good 1700RPM at idle. I came across these Vally View props and I thought I would give them a try. I notice an increase in 200rpm with these props. I did the maiden flight with the Valley View 19x8 prop and the Yak had unlimited vertical. I am new to this type on plane and I was wondering what everyone thinks of these Valley View props?:confused:
BCCHI Tired old C&H guy |
+1......Good Balance ! :)
|
All times are GMT -8. The time now is 04:24 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.