Valley View Props?
#1
Thread Starter
My Feedback: (14)
Valley View Props?
I have a new EME-35 that I am breaking in on a FLY-MODEL Yak-54. I started breaking in the 35 with a Turnigy 19x8 because that is what I had on hand at the time. It seemed to do pretty well and I was getting 7100RPM on the high end with a good 1700RPM at idle. I came across these Vally View props and I thought I would give them a try. I notice an increase in 200rpm with these props. I did the maiden flight with the Valley View 19x8 prop and the Yak had unlimited vertical. I am new to this type on plane and I was wondering what everyone thinks of these Valley View props?
#5
Senior Member
I have a new EME-35 that I am breaking in on a FLY-MODEL Yak-54. I started breaking in the 35 with a Turnigy 19x8 because that is what I had on hand at the time. It seemed to do pretty well and I was getting 7100RPM on the high end with a good 1700RPM at idle. I came across these Vally View props and I thought I would give them a try. I notice an increase in 200rpm with these props. I did the maiden flight with the Valley View 19x8 prop and the Yak had unlimited vertical. I am new to this type on plane and I was wondering what everyone thinks of these Valley View props?
BCCHI Tired old C&H guy