Engine Mount for EV0 35
 

Season Greetings :-) I have a Evolution EVO 35 that uses a standard beam mount. Problem is that I cannot find a good alum beam mount that is rated for this large of engine. I would prefer something with some dampening action but will consider anything at this point. Dubros makes one that is rated for a 180 4 stroke and it appears to be big enough just worried about the rating. Thanks for any help.

Best regards,
Randy

RE: Engine Mount for EV0 35
 

They make a very nice radial mount for it. It attaches to the backplate.

I have one for my MVVS26 and my MVVS35 (same engine)

RE: Engine Mount for EV0 35
 

Yes I seen that but I was after a beam mount to make adjusting the length easier than the radial mount. If I cannot find one I may have to use it though.

Thanks..
Randy

RE: Engine Mount for EV0 35
 

When I was breaking in my 35 on my test bench, I used the largest Great Planes composite mount available.

It held up OK!

Bob

RE: Engine Mount for EV0 35
 

See Item # 3398R at http://www.mvvs.nl/MVVS/main_bestanden/pricelist.html
It is a radial back mount that fits directly to the rear cover. Iso mounts are not included, but you can add dubro mounts without any problem.