|
old gas engine
1 Attachment(s)
Guys
I need ur help,[:o] anyone familiar with this old gas engine, need the manual or instructions for this one,.. Any kind of info is greatly appreciated. Thanks a lot. Hisham |
RE: old gas engine
I'm going to go out on a limb and say it looks a lot like a Power Products engine I had back in the late 60's. Other than that, I can't help ya.
Dr.1 |
RE: old gas engine
The wiring seems a bit confusing
any opinions about the kill switch wires and what should I power the ignition with... Thanks Hisham |
RE: old gas engine
Don't know what it is is, but appears to have some sort of and electronic ignition conversion on it. There is a trigger, or some sort of selfcontained ignition on the flywheel.
Might post in the "conversion engine" forum. Maybe someone there will know. |
RE: old gas engine
Looks like an R/C-type connector for a battery supply to the electronic ignition. The large red wire is the kill switch wire. Simply connect that wire to the crankcase through a SPST switch. It grounds the primary side of the ignition.
Dr.1 |
| All times are GMT -8. The time now is 12:37 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.