RCPilot100

My Feedback: (4)

I finished my Cub. Bought the kit 10 years ago but it took retirement to finish it. About 3 years ago, I lent my plans to a buddy who was going to finish his Cub. Guess what? I didn't get them back - I need to know where the CG is on this bird - before I take it out for its maiden flight. I ran the DA 50 today on the plane - it runs like a swiss watch. I went thru a full tank of fuel taxiing it around my 10 acres. I can't say enough good about the engine. I believe the CG is close - but I want to make sure it is accurate before I go to the field - hopefully next week. If anyone can help, it would be much appreciated.

Dan

b.bixel

My Feedback: (123)

You might just give Balsa USA a call.

Bart