Servo Arms
04-26-2005, 12:17 PM
#1
Thread Starter
My Feedback: (1)
Join Date: May 2003
Location: Grantsville, WV, VA
Posts: 1,753
Likes: 0
Received 0 Likes
on
0 Posts
Servo Arms
Chip, can you recommend some good, high quality servo arms (preferably aluminum or titanium) for Futaba digitals which will fit without slop and allow me to achieve good 3D throw? The last ones I got (from hanger 9 I believe) were sloppy on the gear and I was afraid to use them.
Thanks
Thanks
05-01-2005, 05:50 AM
#2
My Feedback: (8)
RE: Servo Arms
I use the Dubro arms all the time and feel they are as good as any. Don't be afraid of them because they are not made from aluminum or some other exotic metal. Those arms are not any better, just heavier and mch more expensive.
Chip
Chip
ORIGINAL: cstevec
Chip, can you recommend some good, high quality servo arms (preferably aluminum or titanium) for Futaba digitals which will fit without slop and allow me to achieve good 3D throw? The last ones I got (from hanger 9 I believe) were sloppy on the gear and I was afraid to use them.
Thanks
Chip, can you recommend some good, high quality servo arms (preferably aluminum or titanium) for Futaba digitals which will fit without slop and allow me to achieve good 3D throw? The last ones I got (from hanger 9 I believe) were sloppy on the gear and I was afraid to use them.
Thanks
05-01-2005, 06:39 AM
#3
Thread Starter
My Feedback: (1)
Join Date: May 2003
Location: Grantsville, WV, VA
Posts: 1,753
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Arms
Yeah, me too. I was just going for the "High-Tech" look on the plane I am assembling now. Everything is carbon fiber and shiny aluminum (Even some of the covering is that carbon fiber looking Ultracoat) and I am just looking to add to the overall effect of the plane. Thanks for your response.
