RCU Forums - Incidence and thrust for pattern?

RCU Forums (https://www.rcuniverse.com/forum/)

- Giant Scale Aircraft - 3D & Aerobatic (https://www.rcuniverse.com/forum/giant-scale-aircraft-3d-aerobatic-110/)

- - Incidence and thrust for pattern? (https://www.rcuniverse.com/forum/giant-scale-aircraft-3d-aerobatic-110/2545475-incidence-thrust-pattern.html)

tph1	01-16-2005 06:35 AM

Incidence and thrust for pattern?

What are your typical set ponts for a pattern plane , single wing like your Hydeaway? Do you put right and down on the motor? Have wing or stab at 0* and the other positive?
thanks, Tom

Passport1

01-18-2005 12:22 AM

RE: Incidence and thrust for pattern?

Wing is =.5 thrust is 0 and stab is adjusted if elevator trim is required. After that i trim as required to achieve a hands off upline under full power for the length of the current patterns tallest manuever. That is done with the thrust, which is normally not much.

Chip

Quote:

ORIGINAL: tph1

What are your typical set ponts for a pattern plane , single wing like your Hydeaway? Do you put right and down on the motor? Have wing or stab at 0* and the other positive?
thanks, Tom

All times are GMT -8. The time now is 12:30 AM.