Engine test stand for a 1.80?
06-25-2013, 05:46 PM
#1
Thread Starter
My Feedback: (60)
Join Date: Dec 2001
Location: Mooresville, NC
Posts: 1,480
Likes: 0
Received 0 Likes
on
0 Posts
Engine test stand for a 1.80?
Wassup guys. Would anyone happen to know where I could buy a good test stand for my Moki 1.80?
The only ones I've found so far only go up to 1.08 size motors.
Thanks in advance
S
The only ones I've found so far only go up to 1.08 size motors.
Thanks in advance
S
06-26-2013, 03:24 AM
#2
My Feedback: (102)
Join Date: Dec 2001
Location: Colonial Beach, VA
Posts: 20,370
Likes: 0
Received 25 Likes
on
25 Posts
RE: Engine test stand for a 1.80?
http://www.pspmfg.com/RCEngineTestStand.html
Here is one that will handle your 1.80 and then some, I've run my ST 4500 in it both as a glow engine and as a Diesel turning a 22x10. It will even work upside down. Everything about it exudes quality.
Here is one that will handle your 1.80 and then some, I've run my ST 4500 in it both as a glow engine and as a Diesel turning a 22x10. It will even work upside down. Everything about it exudes quality.
