Moki 2.1 Engine
11-19-2003 | 09:40 AM
#3
Senior Member
Joined: Jan 2003
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
From: Fiane, 4993 Sundebru, Norway
RE: Moki 2.1 Engine
Mate, you're another one who needs to acquaint himself with Micro-Fasteners [link]http://www.microfasteners.com[/link] 
If the bolt is 4mm then the thread is 0.7 mm. They wouldn't use metric fine in aluminium. The metric thread is quite fine.
If the bolt is 4mm then the thread is 0.7 mm. They wouldn't use metric fine in aluminium. The metric thread is quite fine.
11-19-2003 | 10:57 PM
#5
Senior Member
My Feedback: (8)
Joined: Nov 2003
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
From: Chico, CA
RE: Moki 2.1 Engine
Hey Shonny--
Metric conversion was foisted upon us by pencil-necked geeks and fastner manufacturers!!! Life was too easy when we had USS and SAE fastners!! Hey and I gotta wonder what is wrong with 10-24, 10-32, 2-56,4-40 is that like way too easy or what!?!? I guess it just didn't cause enough stress around the office!! Thanks Bob
I'm fortunate to have a great nut/bolt shop in town which I haven't been able to stump yet.....many thanks to Valley wide Fastners
Metric conversion was foisted upon us by pencil-necked geeks and fastner manufacturers!!! Life was too easy when we had USS and SAE fastners!! Hey and I gotta wonder what is wrong with 10-24, 10-32, 2-56,4-40 is that like way too easy or what!?!? I guess it just didn't cause enough stress around the office!! Thanks Bob
I'm fortunate to have a great nut/bolt shop in town which I haven't been able to stump yet.....many thanks to Valley wide Fastners
