K&B 8011 / .40
12-06-2004, 02:29 PM
#1
Senior Member
Thread Starter
Join Date: Aug 2004
Location: Roanoke,
TX
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
K&B 8011 / .40
Hey All
Just bought a couple of used 8011s and found them to be in very good condition. One thing that puzzles me, I mounted one to my test stand and realized that the normal 1/4-28 hole in my prop requires enlarging to fit the shoulder on the flange. I enlarged the hole in the prop just deep enough (from the back side) to allow the shoulder to fit snug. Is this normal for these series engines?
Thanks
-Tom
Just bought a couple of used 8011s and found them to be in very good condition. One thing that puzzles me, I mounted one to my test stand and realized that the normal 1/4-28 hole in my prop requires enlarging to fit the shoulder on the flange. I enlarged the hole in the prop just deep enough (from the back side) to allow the shoulder to fit snug. Is this normal for these series engines?
Thanks
-Tom
